Kenmore dryer error code
Your Kenmore dryer does not work properly? Instead of heating, it shows an error code? Perform the troubleshooting process using our step-by-step guide: it explains the meaning of Kenmore error codes and how to eliminate the problem.
Error | Problem |
PF | Power failure |
A power failure occurred while the dryer was running. Press Start to continue the cycle or Stop to clear the display. If frequent power failures occur, check the outlet cord for the dryer. | |
F:01 | Main electronic control board failure |
F:02 | Keypad/user interface failure |
F:20 | Heater relay failure |
F:22 | Outlet thermistor failure |
F:23 | Outlet thermistor failure |
F:24 | Inlet thermistor failure |
F:25 | Inlet thermistor failure |
F:28 | Moisture sensor failure |
F:29 | Moisture sensor failure |
F:30 | Restricted airflow |
F:31 | Low L2 voltage |
F:70 or F:71 | No communication between the electronic control board and the user interface control board assemblies |
F:72 through F:78 | User interface control assembly failure |
Kenmore dryer error code f01
This error code suggests there is a fault in the main electronic control board.
Reset yourdryer by unplugging it for a few minutes and plugging it back in. It the error is still there, the control board needs to be replaced. Run the diagnostic mode just in case. It should be not until you know for sure there is a problem that you start any repair work.
Kenmore elite dryer f70 error code
This error code signals a disconnection between the main control board and console panel. If the error persists, unplug your device, remove the panel and check the wiring. If it is ok, there must be a problem in the main control board. It needs to be repaired or replaced.
Kenmore dryer error code e1
If you see E1 on your dryer’s display, you havve a thermistor problem. Unplug the device and remove the lint filter screen. Undo the two screws from the lower part of the toe-kick panel and remove it (pull it out at the bottom and down). Remove the lint duct bracket (undo the screw holding it). Undo the two screws in the lint duct and remove it. There will be a white thermal fuse on the blower’s housing. The thermistor will be just near it. If you replace the thermistor, the erroor code will disappear.