Eelectrolux dryer error code

Eelectrolux dryer error code e64

Eelectrolux dryer error code e64

This error code indicates a problem with the wiring or heating element. Also, it may occur due to a glitch or power surge. Unplug your dryer (or shut off the home circuit breaker), wait for about 5 minutes, plug it back in and run any of the cycles.

Electrolux dryer error code e63

Electrolux dryer error code e63

If you see this error on the display, the auto-reset thermostate function is down. This may occur due to a fault in the thermostate (the heating element), wiring, or electronic board.

If there is a fault, the Machine Status/Action will cut off power supply to the heater unit. If this does not happen again, the system will memorize the alarm and the cycle will not be interrupted. If the fault is there even after several attempts to restore power, the E62 error code will appear.

Electrolux dryer error code e66

Electrolux dryer error code e66

If you see this error code on the display screen, there may be a wiring issue or the exhaust thermal limiter is tripped. The latter is located on the outlet exhaust pipe. Unplug the device and check the thermal limiter with a volt/ohm meter.

Important! The thermal limiter could have tripped due to a clog or restriction in the exhaust air duct that leads outside your house. Check the vent duct. Failure to do that may cause the exhaust fuse to get blown repeatedly.

Electrolux dryer error code e61

Electrolux dryer error code e61

This one indicates that one or several buttons are stuck. To clear the error, remove the back panel to get to the dryeer’s ‘tech sheet’. It will instruct you how to check the buttons: you are going to use them to launch the test mode.

Enter the ‘function test mode’ and activate the ‘key stuck/active’ test. This will help you find the bad button. Free it and test it again. If the code is still there, and there are no stuck buttons, the electronic control board needs to be repaired or replaced.